Instruction Manual

Casa Series

Model ATA908/758

This page is the accessible web version of the printed instruction manual. It has the same instructions in the same order, and each diagram has a text description.

Components

Box Contents
No.Part
1Frame
2Canopy
3Finial Cap
4Bottom Pole
Diagram: box contents
Box contents, numbered: 1 Frame, shown folded with the ribs closed and a crank handle near the bottom; 2 Canopy, shown folded; 3 Finial Cap, a short flared cap; 4 Bottom Pole, a straight tube with two holes near its top.

Canopy Assembly

  1. Place the umbrella frame on a stable, elevated surface with the top of the frame extending over the edge.

    Diagram: resting the frame on a table edge
    Two drawings. Left: the folded frame is lowered (two downward arrows) onto a table so it rests across the table edge. Right: the frame is slid along the table (arrow pointing left) until the top of the frame, with its threaded hub top, extends past the table edge.
  2. Unfold the canopy. Insert one arm underneath the canopy and locate the small opening at the center. Please note, the canopy should be inside out in this step.

    Diagram: reaching under the canopy to find the center opening
    Two drawings of a person holding the unfolded canopy. Left: a curved arrow shows one arm reaching up underneath the canopy fabric. Right: the hand pushes up through the canopy and the fingertips emerge at the small center opening (arrow pointing up and to the right).
  3. Use the same hand that is inside the canopy to grip the protruding thread at top of the frame. While maintaining the grip, use the other hand to flip the canopy over the frame.

    Diagram: gripping the frame top and flipping the canopy over
    Two drawings. Left: the hand inside the canopy, with the center opening around the fingers, reaches toward the top of the frame (arrow pointing at the top of the frame, which shows the threaded hub top). Right: the canopy opening now sits on the top of the frame and a curved arrow shows the rest of the canopy being flipped over the frame.
  4. Adjust the small opening of the canopy until the threaded end is fully exposed. Screw the finial cap on clockwise to secure the canopy.

    Diagram: screwing the finial cap onto the threaded end
    Two drawings. Left: the canopy is gathered over the top of the frame with the threaded end showing through the small center opening. Right: a hand turns the finial cap (short flared cap) onto the threaded end; a curved arrow shows the turning direction.
  5. Temporarily lift the assembled frame and canopy to allow the canopy to fully drape over the frame.

    Diagram: lifting the frame so the canopy drapes over it
    Two drawings, linked by an arrow pointing right. Left: the frame with the finial cap attached rests on the table edge while the canopy hangs over it; curved arrows show the frame being lifted and the canopy falling over the frame. Right: the canopy now drapes evenly along the length of the frame.
  6. Locate the rib pockets at the bottom of the canopy. One at a time, pull each pocket down and insert the corresponding rib to complete the assembly. To remove the canopy, follow these steps in reverse order.

    Diagram: fitting rib ends into the canopy rib pockets
    Two drawings. Left: hands pull a rib pocket at the edge of the canopy down the frame (two arrows pointing toward the rib ends) while the ends of the ribs are visible below. The crank housing and handle of the frame are visible at the lower left. Right: close-up of a rib end being seated in a rib pocket; two arrows point to the pocket from above and below.

Installation

Warning

  • Base is required for this umbrella and sold separately.
  • Umbrella should always be closed and secure with wind-tie in windy conditions
  1. Secure the umbrella bottom pole to a compatible base (sold separately).

    Diagram: securing the bottom pole in a base
    The bottom pole is lowered (downward arrow) into the post of a square base drawn in dashed lines (base sold separately). A circular close-up shows the base post collar with a round knob on its side; curved arrows on both sides of the knob show it being turned to tighten.
  2. Align the bottom portion of the frame to the opening of the bottom pole.

  3. Locate the metal push button near the bottom of the frame. Press the button inward while inserting the frame into the bottom pole.

  4. Slowly rotate the frame to align the metal push button with the hole. Once there is a click, both parts are secured.

    Diagram: joining the frame to the bottom pole with the push button
    One drawing covers Steps 2 to 4. The closed umbrella, canopy wrapped and tied, is lowered (downward arrow) toward the bottom pole standing in a square base. Upper close-up, labeled PRESS: a hand presses the metal push button on the lower end of the frame inward (arrow pointing at the button). Lower close-up, labeled CLICK: the frame tube slides down over the bottom pole (downward arrow) and the push button pops out through the hole in the outer tube (arrow pointing outward).

Shop umbrella bases

Operation

Opening and Closing

Opening

Turn the crank handle clockwise until the umbrella is fully open.

Diagram: turning the crank clockwise to open
Left: close-up of the crank handle on the pole with a curved arrow labeled Clockwise. Right: the umbrella shown open, with dotted arrows at both canopy edges pointing outward and up.

Closing

Turn the crank handle counterclockwise until the umbrella is fully closed, please operate slowly to avoid injury.

Diagram: turning the crank counterclockwise to close
Left: close-up of the crank handle with a curved arrow labeled Counter Clockwise. Right: the umbrella shown closed, with dotted arrows pointing inward toward the pole.

Tilting

Engage Tilt

Once the umbrella is fully open, continue to turn the crank handle clockwise to engage the tilt.

Diagram: continuing to crank clockwise to tilt
Left: close-up of the crank handle with a curved arrow labeled Continue Clockwise. Right: the open canopy shown tilted to one side, with a dotted arrow at the raised edge pointing up.

Disengage Tilt

Turn the crank handle counterclockwise to return umbrella to its upright position.

Diagram: cranking counterclockwise to return upright
Left: close-up of the crank handle with a curved arrow labeled Counter Clockwise. Right: the open canopy shown level again, with a dotted arrow at one edge pointing down.

Care & Maintenance

Care Tips

  • Use an appropriate base or anchoring system to secure the umbrella. Verify the recommended base weight for the item.
  • Base and umbrella are meant to lay on a flat surface.
  • Always move the umbrella by uninstalling and lifting/placing in desired area.
  • Add a fabric defense to your umbrella canopy for an added layer of protection against oil and water-based stains. Visit our website to purchase a bottle of Pacifica Preserve and Protect Fabric Defense.

General Warnings

  • The appropriate base or anchoring system is needed to provide stability for the umbrella. Please verify the recommended base weight for the item.
  • May cause damage or injury when used improperly.
  • Not meant for commercial use.
  • Not meant for use in windy or inclement weather conditions.
  • When not in use, cover and store outdoor furniture in a dry and clean area.
  • Do not use harsh cleaning products on the surface of your frame or canopy.

How to Clean

  • Frame
    • To keep the umbrella frame looking new, wipe the frame with a clean damp cloth and a solution of mild soap and water¹. Dry with a clean dry cloth. While canopy is installed, use a soft bristle brush to regularly remove any loose dirt, leaves, and other debris from fabric.
    • To remove water spots, use a clean cloth or soft bristle brush to scrub the frame with a solution of white vinegar and water². Dry with a clean dry cloth.
  • Canopy
    • While canopy is installed, use a soft bristle brush to regularly remove any loose dirt, leaves, or other debris from the fabric.
    • For spills and stains, spray a mild cleaning solution of mild soap and water¹ and scrub with a soft bristle brush or a clean cloth.
    • For more severe cases, purchase the Pacifica: Restore and Renew Fabric Cleaner. Spray the canvas 10 inches way from the surface, use a soft bristle brush to scrub the fabric. Thoroughly remove any residue with clean water.
    • Machine Wash Cold and Air Dry Only.
  • Cleaning Solution
    • Mild Soap and Water: ¼ cup mild soap : 1 gallon water
    • White Vinegar and Water: 1 cup vinegar : 1 cup water

Warranty

Overview

California Umbrella’s limited warranty gives you specific legal rights and you may also have other rights, which vary from state to state.

This limited warranty can also be found at www.californiaumbrella.com/en/terms-of-sales#warranty and in the documentation we provide with the products.

We warrant that during the warranty period, the individual components of the products purchased from the site will be free from defects in materials and workmanship.

We limit the duration and remedies of all implied warranties, including without limitation the warranties of merchantability and fitness for a particular purpose, to the duration of this limited warranty. Our responsibility for defective products is limited to repair, replacement or refund as set forth in this warranty statement. Neither any performance or other conduct, nor any oral or written information, statement or advice provided by us, our agents, or employees will create a warranty, or in any way increase the scope or duration of this limited warranty.

Frames

  • Aluminum frames: 1-year limited warranty
  • Fiberglass Ribs: 3-year limited warranty
  • If a residential grade umbrella is used for commercial purposes, the warranty is reduced to 90 days.

Canopies

  • All canopies: 1-year limited workmanship warranty
  • Olefin fabric: 1-year limited warranty
  • Pacifica fabric : 4-year limited warranty
  • Sunbrella fabric : 5-year limited warranty
  • Sunbrella Awning fabric : 10-year limited warranty

Contact us through our ticketing system on californiaumbrella.com for warranty inquiries.

Questions about your product? Contact us or chat with us on californiaumbrella.com.

All product guides